Skip to Main Content


Following earlier work by Hon (1958), continuous electronic fetal monitoring (EFM) was introduced into obstetrical practice in the late 1960s. No longer were intrapartum fetal surveillance and the suspicion of fetal distress based on periodic auscultation with a fetoscope. Instead, the continuous graph-paper portrayal of the fetal heart rate was potentially diagnostic in assessing pathophysiological events affecting the fetus. Indeed, there were great expectations: (1) that electronic fetal heart rate monitoring provided accurate information, (2) that the information was of value in diagnosing fetal distress, (3) that it would direct intervention to prevent fetal death or morbidity, and (4) that continuous electronic fetal heart rate monitoring was superior to intermittent methods.

When first introduced, electronic fetal heart rate monitoring was used primarily in complicated pregnancies, but gradually became used in most pregnancies. By 1978, it was estimated that nearly two thirds of American women were being monitored electronically during labor (Banta, 1979). Currently, more than 85 percent of all live births in the United States undergo electronic fetal monitoring (Ananth, 2013). Indeed, fetal monitoring has become the most prevalent obstetrical procedure in this country.

Electronic Fetal Monitoring

Internal (Direct) Electronic Monitoring

The fetus can be monitored electronically by direct or indirect methods. Direct fetal heart measurement is accomplished by attaching a bipolar spiral electrode directly to the fetus (Fig. 24-1). The wire electrode penetrates the fetal scalp, and the second pole is a metal wing on the electrode. Vaginal body fluids create a saline electrical bridge that completes the circuit and permits measurement of the voltage differences between the two poles. The two wires of the bipolar electrode are attached to a reference electrode on the maternal thigh to eliminate electrical interference. The electrical fetal cardiac signal—P wave, QRS complex, and T wave—is amplified and fed into a cardiotachometer for heart rate calculation. The peak R-wave voltage is the portion of the fetal electrocardiogram most reliably detected.

Figure 24-1

Internal electronic fetal monitoring. A. Scalp electrode penetrates the fetal scalp by means of a coiled electrode. B. Schematic representation of a bipolar electrode attached to the fetal scalp for detection of fetal QRS complexes (F). Also shown is the maternal heart and corresponding electrical complex (M) that is detected.

An example of the method of fetal heart rate processing employed when a scalp electrode is used is shown in Figure 24-2. Time (t) in milliseconds between fetal R waves is fed into a cardiotachometer, where a new fetal heart rate is set with the arrival of each new R wave. As also shown in Figure 24-2, a premature atrial contraction is computed as a heart rate acceleration because the interval (t2) is shorter than the preceding ...

Pop-up div Successfully Displayed

This div only appears when the trigger link is hovered over. Otherwise it is hidden from view.